|
|
|||||||
|
|
||||
 |
|
|
|
|
|
|
|
|
|
 |
|
||||||||
|
|
|
|
|
|
|
|
|
|
|
Bandsaw technology for plate finishing The first plate stack up cut is done on a transverse bandsaw. Then in the directly adjacent process two longitudinal bandsaws cut parallel on the left and right side the plates to the correct dimensions. The bandsaws are positioned on the right and left side of the transport roller conveyor. Scrap and chips are transported automatically out of the cell, chips are then pressed to briquettes. |
|
|||||||
|
|
|
|
|
|
||||
|
 |
|
|||||||
|
|||||||||
|
|||||||||
|
|||||||||
|
Typical performance: (Width × length × thickness in mm) Plate raw dimensions: max. 1050 up to 1800 × 3200 up to 19000 × 19 up to 120 Plate finished dimensions: 800 up to 1600 × 2000 up to 6000 × 19 up to 120 Stack up height: up to 300 mm Material removal rate: up to 3.000 cm²/min. |
 |
|
||||||
|
|||||||||
|
|||||||||
 |
|||||||||
|
|||||||||
The installation consists of:
|
 |
||||||||
|
|||||||||
|
|||||||||